300-360試験概要,300-360受験記対策,300-360難易度,300-360ITパスポート

Ktestは300-360試験参考書語認定試験に合格することを助けてあげますから。購入前にKtestが提供した無料の問題集をダウンロードできます。自分の練習を通して、試験のまえにうろたえないでしょう。Ktestを選択して専門性の訓練が勉強者の試験によいだと思います。Ktestは客様の要求を満たせていい評判をうけいたします。たくさんのひとは弊社の商品を使って、試験に順調に合格しました。そして、かれたちがリピーターになりました。Ktestが提供したCiscoの300-360試験参考書語試験問題と解答が真実の試験の練習問題と解答は最高の相似性があり、一年の無料オンラインの更新のサービスがあり、300-360試験参考書%のパス率を保証して、もし試験に合格しないと、弊社は全額で返金いたします。

Share some CCNP Wireless 300-360 exam questions and answers below.
An engineer is performing a predictive wireless design for a carpeted office space, which requires voice capability and location services.

Which two requirements are inputs to the design? (Choose two.)

A. overlapping -67 dBm coverage from three access points

B. overlapping -75 dBm coverage from three access points

C. overlapping-72 dBm coverage from two access points

D. continuous -67 dBm coverage from one access pointe. continuous -72 dBm coverage from one access point

Answer: BD

After the completion of a site survey with Ekahau Site Survey tool, using the default color palette, it is noted that multiple areas are shown as white on the heat map when viewing 5 GHz signal strength data.

What does this indicate about the signal strength?

A. The area is below the minimum threshold configured on the tool.

B. The area is below the detectable level and indicates no RF signal.

C. The area is below -100 dBm at coverage cell edge.

D. The area is below -67 dBm at coverage cell edge.

Answer: A

Which two options describe best practices that must be completed after a wireless installation is finished? (Choose two.)

A. Make sure that there are no spaces between the devices on the rack that the Wireless Lan Controller is installed.

B. Consult with the customer to ensure that the IT staff has a complete set of design and installation documents.

C. Make sure the customer is aware that they should consider purchasing a support contract immediately after the installation is complete.

D. Spend time with the customer to show them the controller GUI and inform them how they can reach the Cisco TAC if they have any problems.

E. Test all the customer¡¯s wireless devices and applications to ensure they are working properly.

Answer: B,E

A Cisco 7925 phone at a client¡¯s location is not registering with CUCM. The engineer analyzes a packet capture, sees that the phone receives an IP, and downloads the proper configuration file from TFTP successfully.

What type of messages should the phone be sending at this point?

A. H.245

B. H.323

C. MCGP

D. SCCP

Answer: D

A Cisco 7925 phone at a client’s location is not registering with CUCM. The engineer analyzes a packet capture, sees that the phone receives an IP, and downloads the proper configuration file from TFTP successfully. What type of messages should the phone be sending at this point?

A. H.245

B. H.323

C. MCGP

D. SCCP

Answer: D

An engineer must design wireless coverage in thick-walled stairwells. Which information should the engineer refer to when determining where APs can be installed?

A. Local or National Building Code

B. IEEE

C. BICSI TDMM

D. Cisco Hardware Installation Guide

Answer: A

An engineer is performing a predictive wireless design for a medical treatment environment, which requires data and voice services. Which of the following is a requirement for the design?

A. overlapping -72 dBm coverage from two access points

B. overlapping -67 dBm coverage from two access points

C. continuous -67 dBm coverage from one access point

D. continuous -72 dBm coverage from one access point

Answer: C

An 802.11n implementation is being discussed. Users are satisfied with the potential 300­450 Mbps throughput of new 802.11n APs.

Which three bandwidth requirements are used to calculate per client bandwidth through an 802.11n AP network? (Choose three.)

A. 450 Mbps throughput is the client max for 5-GHz radio.

B. Channel bonding on 5 GHz is required for a client to have a 300 Mbps WiFi link.

C. 300 Mbps throughput is the client max for 2.4-GHz radio.

D. The remaining bandwidth is divided per device when more clients are connected to one AP.

E. 100 Mbps Ethernet switch port is a potential bottleneck.

F. Clean Air helps clear noise for 802.11n channel bonding to work.

Answer: A,C,E

皆勉強者は最高のIT資格専門家になりますか？その夢は私たちには遠い。でも、成功の近い道路が見つかりました。Ktestの試験問題集を助けることができ、300-360試験に合格することができます。KtestのCCNP Wireless認定資格300-360試験問題集を使って、試験に合格しなければ、全額で返金できます。KtestのCiscoの300-360試験問題集はIT認証に対する最高のトレーニング資料ですから。Designing Cisco Wireless Enterprise Networks資料は最完全かつ最新で、合格率が非常に高いということで人々に知られています。それを持っていたら、勉強者は大切の時間とエネルギーを節約できます。Ktest試験問題集を利用すれば、スムーズに試験に受かることができます。

サイトはKtestです。Ktestのガイダンスとヘルプを通して、初めにCCNP Wireless資格のDesigning Cisco Wireless Enterprise Networks学習資料の認証を受けるあなたは、気楽に試験に合格すことができます。Ktestが提供した問題と解答は現代の活力がみなぎる情報技術専門家が豊富な知識と実践経験を活かして研究した成果で、あなたが将来IT分野でより高いレベルに達することに助けを差し上げます。